Possible faults and solutions of mineral dressing shaking table

There are several possible faults that can occur in a mineral dressing shaking table, and here are some possible solutions:

1. Uneven feeding: If the feeding is not evenly distributed, it may cause the table to shake unevenly, resulting in insufficient separation. To solve this problem, evenly distribute the feeding materials on the table.

2. Insufficient washing water: If there is insufficient washing water, it may cause the materials to stick to the surface of the table, reducing the separation efficiency. To solve this problem, adjust the quantity of washing water to ensure that there is enough for efficient separation.

3. Table inclination: If the table is not adjusted to the correct inclination, it may cause the materials to flow too fast or too slow on the table, reducing the separation efficiency. To solve this problem, adjust the inclination of the table to the optimal level.

4. Worn out parts: If the parts of the shaking table are worn out or damaged, it may cause operational problems. To solve this problem, replace the worn-out parts with new ones.

5. Mechanical failure: If the shaking table experiences mechanical failures, such as unbalanced motions or broken parts, it may cause severe operational problems. To solve this problem, repair or replace the damaged components.

Overall, regular maintenance and checking can help prevent potential faults and ensure the smooth operation of a mineral dressing shaking table.

Possible faults and solutions of mineral dressing shaking table can include:

1. Unstable table surface:

- Check if the table legs are firmly fixed and it is on a flat surface;

- Check if the table beams and bearings are loose or worn out, and replace if necessary.

2. Low separation efficiency:

- Check if the feed rate is appropriate, and adjust if necessary;

- Check if the water flow rate, frequency, and stroke frequency are appropriate, and adjust if necessary;

- Check if the riffles and surface of the table are clean and free of obstructions, and clean if necessary.

3. Low recovery rate:

- Check if the feed size is appropriate, and adjust if necessary;

- Check if the feed is evenly distributed across the table, and adjust if necessary;

- Check if the inclination angle of the table is appropriate, and adjust if necessary.

4. Excessive wear of table surface:

- Check if the feed material is too abrasive or contains too much clay, and adjust if necessary;

- Check if the table surface is made of durable material, and replace if necessary.

5. Table vibration or noise:

- Check if the table is overloaded, and reduce the feed rate if necessary;

- Check if the table surface is damaged, and repair or replace if necessary;

- Check if the drive belts and bearings are worn out or misaligned, and replace or adjust if necessary.

| Possible Faults | Solutions |

| --- | --- |

| Low concentrating ratio | Adjust the stroke and frequency of the shaker or adjust the water flow |

| Ore particles are not evenly distributed on the deck surface | Clean the deck surface and adjust the feed distribution device |

| The layering of ore particles on the deck surface is not ideal | Adjust the tilt angle of the deck surface |

| Shaking table is unstable during operation | Check the foundation and level the shaking table |

| Low separation efficiency and poor concentrate quality | Adjust the feed flow and particle size, and check the wear of the deck surface and supporting structures |

| Deck surface wears out quickly | Replace the deck surface with a new one and improve the quality of the deck surface material |

| Motor and drive system failure | Check the motor, drive belts, and other components in the drive system, and replace or repair them as necessary |